26 Ryoga SV 100
Daiwa2026

Daiwa 26 Ryoga SV 100 Tuning

Tuning Specs
Handle bore 8x5
Spool bearing sizes 5x11x4 | 3x10x4
Recommended bearing class Edge
Pin Remover Erforderlich
These sizes are precisely tailored to the reel — we’ve deliberately hidden the others so you can find the right tuning parts straight away.
Recommended knob sizes
21–24 mm25–27 mm30–40 mm
Recommended handle lengths
90–105 mm110–120 mm
Let’s tune your reel
Available variants
100 P
100 PL
100
100 L

Matching tuning parts for your Ryoga

There are currently no compatible tuning parts listed for this reel.

The Daiwa 26 Ryoga SV 100 is the new low-profile generation of the Ryoga line with an aluminum body, SV spool, and round reel DNA for bass and all-round use. Available in PG (5.5:1) and Normal (6.3:1), each in right- and left-handed versions.

Frequently asked questions about tuning the Daiwa 26 Ryoga SV 100

Which spool bearings fit the Daiwa 26 Ryoga SV 100?
The Daiwa 26 Ryoga SV 100 uses spool bearings in 5x11x4 and 3x10x4 (inner × outer × width in mm). You'll find matching tuning spool bearings in exactly this size on this page under the tuning parts. To swap them on this reel you need a Pin Remover, because the bearings are secured to the shaft with pins.
Which bearing class do we recommend for the 26 Ryoga SV 100?
For the Daiwa 26 Ryoga SV 100 we recommend EDGE, the balanced middle class. A clearly noticeable gain in casting distance and smoothness at a very good price-performance ratio. The recommendation is based on how this reel is typically used.
Which handle and knobs fit the 26 Ryoga SV 100?
The handle fitting of the Daiwa 26 Ryoga SV 100 is 8x5 (wrench size × shaft diameter in mm). Every tuning handle with a 8x5 fitting fits directly. Tuning knobs in the sizes shown on this page fit the stock handle and our tuning handles.
Do I need special tools to change the bearings on the 26 Ryoga SV 100?
Yes. On the Daiwa 26 Ryoga SV 100 the spool bearings are secured to the spool shaft with pins. A Pin Remover lets you pull the pins out cleanly without bending the shaft. Apart from that you only need a suitable screwdriver for the side plate.
Can you install the tuning on my 26 Ryoga SV 100?
Yes. Send us your Daiwa 26 Ryoga SV 100, we'll install the tuning parts professionally, clean and oil the reel and send it back ready to fish. You'll find the tuning service via the button above.