24 Scorpion MD 300
Shimano2024

Shimano 24 Scorpion MD 300 Tuning

Tuning Specs
Handle bore 8x5
Spool bearing sizes 5x11x4 | 3x10x4
Recommended bearing class Edge
Pin Remover Erforderlich
These sizes are precisely tailored to the reel — we’ve deliberately hidden the others so you can find the right tuning parts straight away.
Recommended knob sizes
21–24 mm25–27 mm30–40 mm
Recommended handle lengths
90–105 mm110–120 mmSingle Handle
Let’s tune your reel
Available variants
300 XG
301 XG
300 XGLH
301 XGLH

Matching tuning parts for your Scorpion

There are currently no compatible tuning parts listed for this reel.

The Shimano 24 Scorpion MD 300 is a big-body baitcaster from the JDM Scorpion MD line with an aluminum body and a 300-size spool for big baits, muskie, and saltwater. Released only in XG (7.4:1), with standard and LH handle variants.

Frequently asked questions about tuning the Shimano 24 Scorpion MD 300

Which spool bearings fit the Shimano 24 Scorpion MD 300?
The Shimano 24 Scorpion MD 300 uses spool bearings in 5x11x4 and 3x10x4 (inner × outer × width in mm). You'll find matching tuning spool bearings in exactly this size on this page under the tuning parts. To swap them on this reel you need a Pin Remover, because the bearings are secured to the shaft with pins.
Which bearing class do we recommend for the 24 Scorpion MD 300?
For the Shimano 24 Scorpion MD 300 we recommend EDGE, the balanced middle class. A clearly noticeable gain in casting distance and smoothness at a very good price-performance ratio. The recommendation is based on how this reel is typically used.
Which handle and knobs fit the 24 Scorpion MD 300?
The handle fitting of the Shimano 24 Scorpion MD 300 is 8x5 (wrench size × shaft diameter in mm). Every tuning handle with a 8x5 fitting fits directly. Tuning knobs in the sizes shown on this page fit the stock handle and our tuning handles.
Do I need special tools to change the bearings on the 24 Scorpion MD 300?
Yes. On the Shimano 24 Scorpion MD 300 the spool bearings are secured to the spool shaft with pins. A Pin Remover lets you pull the pins out cleanly without bending the shaft. Apart from that you only need a suitable screwdriver for the side plate.
Can you install the tuning on my 24 Scorpion MD 300?
Yes. Send us your Shimano 24 Scorpion MD 300, we'll install the tuning parts professionally, clean and oil the reel and send it back ready to fish. You'll find the tuning service via the button above.